54Mbps Wireless G Access Points
Definition: In Wi-Fi networking, Bridge mode allows ii or to a greater extent than wireless access points (APs) to communicate alongside each for the role of joining multiple LANs.
Some wireless bridges back upwards solely a unmarried point-to-point connexion to but about other AP. Others back upwards point-to-multipoint connections to several other APs. This article is virtually how to setup Point to Point Bridge.
Step 1
Connect your estimator to a AP alongside the difficult wired connection, together with and then log into the Web-based Interface yesteryear entering the IP address 192.168.1.1/192.168.1.254 into Web Browser.
If you lot cannot log into the Web-based Interface, delight click here together with follow the pedagogy for a try.
Step 2
Change the LAN IP address of the access indicate to avoid IP conflict if necessary. Please get upwards to FAQ_173 for but about detailed information.
After changing the IP address of your access point, you lot postulate re-log into it yesteryear using the novel IP address. And delight banking concern complaint that the IP addresses of the ii access points cannot move the same inward your network.
Step 3
Configure your Access Point to Point to Point Bridge mode.
1. Click on Wireless ->Basic Settings on the left menu, alter the channel to a fixed one.
2. Click Wireless -> Wireless Mode on the left, conduct Bridge (Point to Point).
3. Press Survey or Search push on the bottom, together with then an AP listing volition move displayed. Locate the BSSID(MAC address) of the other access point, think the Channel-> Click Connect.
4. Then you lot volition come across the MAC addresses of the other access indicate displayed inward the MAC of AP boxes.
5. Click on Save push to salvage the settings.
7. Go to System Tools-Reboot to reboot the device.
Step 4
Configure the other Access Point to Point to Point Bridge mode every bit same every bit the inward a higher house steps.
Note:
1. The channel together with the security settings (security type & password) should move identical on the ii access points.
2. The IP address should move the same subnet but different. For example, if the IP address of the AP1 is 192.168.1.254, the IP address of the AP2 should move 192.168.1.X (1X<254). No IP addresses tin move the same inward your whole network.
Additional information:
There is an selection called With AP Mode inward the setting page. If you lot enable it, the access indicate tin operate inward AP vogue at the same fourth dimension when it has been configured to Bridge mode. This way that you lot tin connect other wireless clients to this access indicate when it has been configured to Bridge mode.
Otherwise you lot cannot connect whatever wireless customer to this access indicate when it has been configured to Bridge mode.
