Configuring An Access Betoken Inwards Access Betoken Customer Mode

Linksys Wireless-G Access Points tin hold out configured every bit an Access Point, Access Point Client, Wireless Repeater in addition to Wireless Bridge. The Access Point Client means allows the WAP54G to act every bit a wireless client. 

NOTE: The WAP54G volition solely communicate amongst to a greater extent than or less other WAP54G when gear upwardly to Access Point Client.
To configure the access indicate every bit an access indicate client, you lot necessitate to perform iii steps:

1. Checking the Wireless MAC Address of an Access Point
2. Setting-Up Access Point Client Mode on the WAP54G
3. Changing the LAN IP Address of the Access Point Client  

Checking the Wireless MAC Address of an Access Point
NOTE: The next steps volition hold out performed on the primary access indicate using a wired computer.

Step 1:Connect a figurer to the access point.

Step 2:Assign a static IP address on the computer. For instructions, click here.
NOTE: To assign a static IP address on a wired Mac, click here.
Step 3:Open the access point’s web-based setup page. For instructions, click here.
NOTE: If you lot are using Mac to access the access point’s web-based setup page, click here.

Step 4:When the access point’s web-based setup page opens, click Status in addition to then click Wireless Network.

Step 5:Take complaint of the Wireless Network MAC Address.

NOTE: The Wireless MAC Address you lot took complaint of volition hold out entered on the WAP54G gear upwardly every bit access indicate client. 

Step 6:After obtaining the wireless MAC address of the access point, configure the other WAP54G inward access indicate customer mode. For instructions, follow the steps below.

Setting-Up Access Point Client Mode on the WAP54G

Step 1:Connect a figurer to the access indicate you lot desire to configure every bit an AP client. 

Step 2:Assign a static IP address on the computer. For instructions, click here.
NOTE: To assign a static IP address on a wired Mac, click here.

Step 3:Open the access point’s web-based setup page. For instructions, click here.
NOTE: If you lot are using Mac to access the access point’s web-based setup page, click here.
Step 4:When the access point’s web-based setup page opens, click AP Mode.

NOTE: The access point’s web-based setup page may differ depending on the access point’s version number.
Step 5:Select AP Client in addition to type the remote access point’s MAC address that you lot took complaint of earlier.
NOTE: Remove the colons (:) when typing the MAC address on the Remote Access Point’s LAN MAC Address field.

NOTE: You may also click Site Survey in addition to pick out the remote access indicate you lot desire to connect to.
Step 6:
Click .

Changing the LAN IP Address of the Access Point Client
After configuring the access indicate every bit an AP client, modify its LAN IP address to avoid IP address conflict.